Upgrading everyday security Commpact Uživatelský manuál stáhnout pdf (Strana 43)

Install a Partner Service

If the partner solution includes a host-resident virtual appliance, you can install the service after you register

the solution.

Prerequisites

If you have not registered third party solutions with NSX Manager, you must manually add the solution to

NSX Manager before you can install the service. See Chapter 5, “Extensibility (Integrate Partner Solutions

with NSX),” on page 41.

Ensure that NSX Manager can access the partner solution's management console.

Procedure

1 Click Networking & Security and then click Installation.

Click the Service Deployments tab and click the New Service Deployment (

) icon.

3 In the Deploy Network and Security Services dialog box, select the appropriate solution(s).

4 In Specify schedule (at the bottom of the dialog box), select Deploy now to deploy the solution

immediately or select a deployment date and time.

5 Click Next.

6 Select the datacenter and cluster(s) where you want to deploy the solution and click Next.

7 On the Select storage page, select the datastore on which to add the solution service virtual machines

storage or select Specified on host.

The selected datastore must be available on all hosts in the selected cluster.

If you selected Specified on host, the datastore for the ESX host must be specified in the AgentVM

Settings of the host before it is added to the cluster. See vSphere API/SDK Documentation.

8 Click Next.

9 On the Configure management network page, select the distributed virtual port group to host the

management interface. This port group must be able to reach the NSX Manager’s port group.

If the network is set to Specified on host, the network to be used must be specified in the Agent VM

Settings > Network property of each host in the cluster. See vSphere API/SDK Documentation.

When you add a host(s) to the cluster, the Agent VM Settings > Network property for the host must be

set before it is added to the cluster.

The selected port group must be available on all hosts in the selected cluster.

10 In IP assignment, select one of the following:

Select To

DHCP

Assign an IP address to the service virtual machine through Dynamic Host

Configuration Protocol (DHCP).

An IP pool

Assign an IP address to the service virtual machine from the selected IP

pool.

11 Click Next and then click Finish on the Ready to complete page.

12 Monitor the deployment till the Installation Status displays Successful. If the status displays Failed,

click the icon next to Failed and take action to resolve the error.

Chapter 5 Extensibility (Integrate Partner Solutions with NSX)

VMware, Inc. 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 57 58

Žádné komentáře

Upgrading everyday security Commpact Uživatelský manuál Strana 43